Saitek Cybrog Evo Force | Calibration and rudder probs

[GbeTech]

Hey, ive recently bought this joystick, but it seems always a bit uncalibrated, and the rudder axis tends a little right:



If I move the stick a bit it resets but after a while, while playing BF2 it seems uncalibrated again.

Same for the rudder issue, I like can't take off because the jet goes right
If I turn the stick right and leave - the rudder resets - but every single move return it to the former state :hmm:

Any ideas?


P.S.
Ive talked with the store I bought the joystick from, they agreed to replace it with another one but all the units are sold out. So I need to wait till the next supply delivery.
I'm afraid it's not that specific joystick but something with the coordination between my computer and the stick. Should I replace the ST with a extreme 3d pro and get a credit for the change? Or try to fix the prob / try another unit?

[TheEn|gma]

Re: Saitek Cybrog Evo Force | Calibration and rudder probs

If I am interpreting what you mean correctly, your stick is drifting slightly. I'm not sure that the Cyborg software has this setting but oh well.

Look for something along the line of "deadzones". If you don't know what they are basically you can set a certain amount of movement on your stick from the center that you wish to be ignored by the stick and not relayed onto the computer.

To rectify this once you have found the deadzone tab or whatever, increase the rudder axis deadzone (the sliders should move at the same time and be symmetrical away from the center) slightly until you feel that it will cover the drift that you are having, it is mostly trial and error.

[GbeTech]

Re: Saitek Cybrog Evo Force | Calibration and rudder probs

sorry no deadzone control anywhere. Not in the control panel neither the profile programming software I got with the stick :hmm: